DVA T8

Line Arrays
Back to gallery
Line Arrays
240 mm 580 mm 327 mm

3-WAY ACTIVE LINE ARRAY MODULE

700W RMS DIGIPRO G2 AMP TECHNOLOGY

132 dB MAX SPL

FREQUENCY RESPONSE [-6 dB]: 60 - 18.000 Hz

HF: 2x 1", 1.4” v.c. NEODYMIUM

MF: 1x 6.5", 2" v.c. - NEODYMIUM

LF: 1x 8", 2.5” v.c. - NEODYMIUM

Sales & Rental Network
DVA T8 est un système actif à 3 voies équipé d'un woofer de 8", d'un médium de 6,5" vc 2" et de deux tweeters à compression de 1" qui offrent une linéarité et un impact sonore sans précédent dans les systèmes de cette taille. Avec une puissance de 700 W/RMS, ce système garantit d'excellentes performances dans des espaces même très grands. La dispersion du module unique de 100° (horizontal) et 15° (vertical) permet une large diffusion du son même en présence de peu de modules. Le contrôle total du système est géré via le protocole RDNET par le logiciel dBTechnologies Network. Sur le panneau arrière du module, il est possible de sélectionner l'égalisation parmi 9 présélections + 1 présélection utilisateur qui permet de personnaliser l'égalisation et de la rappeler à chaque utilisation ultérieure, même déconnectés du réseau Network. De cette manière, on adapte la réponse en fréquence du module à la distance de pointage et au couplage avec d'autres modules dans le même array, en optimisant le son de manière équilibrée et cohérente sans utiliser de processeur externe. En outre, le module est équipé d'un port USB qui permet de mettre à jour le firmware et d'avoir accès aux données de télémétrie telles que la température, les heures d'utilisation et le diagnostic. Toujours au dos du module se trouvent les mécaniques qui permettent de déterminer l'angle entre deux modules, par pas de 1,5, 2 ou 2,5 degrés. Chaque caisson est équipé d'une housse anti-pluie intégrée qui protège les pièces électroniques. Les composants électroniques sont logés dans un caisson en polypropylène renforcé par une armature métallique qui limite les résonances avec optimisation de la réponse acoustique. Le choix soigné des composants au néodyme, des matériaux du caisson et une technologie d'amplification numérique de pointe détermine un rapport poids/performances inégalable : chaque module T8 ne pèse en effet que 14,2 kg (31,3 livres). Il est possible d'assembler facilement des array jusqu'à 16 éléments grâce au flybar (système de suspension) DRK-10 ou 16 éléments avec le flybar drk20, ou la version motorisée drk20. Les flybars peuvent être retournés et utilisés en configuration empilée, posés sur scène ou accrochés au-dessus des subs de la série DVA. En alternative, 2 ou plusieurs modules de T8 peuvent être montés sur un mât 35 mm avec l'accessoire DSA4
En savoir plus

TECHNOLOGIES

Aurora Net
Aurora NetThis product is fully-compatible with Aurora Net software
Digipro® G2
Digipro® G2System of digital amplification engineered by dBTechnologies. Based on the previous Digipro project, the newest G2 versions' efficiency has been improved by cutting down on consumption and heating. The introduction of a 'new avant-garde' component, a better s/n relation and a lighter weight, confer a superior dynamism to the new Digipro G2 digital speakers.
Neodymium Transducers
Neodymium TransducersNeodymium is a metal belonging to the family of the “rare earth”, a particular material which creates a powerful magnetic field once charged. This material, used in acoustic transducers, possesses a far superior magnetic power compared to the classical ferrite which allows its dimensions to be reduced, favoring its weight and space capacity.
PFC (Power Factor Corrector)
PFC (Power Factor Corrector)The Power Factor Corrector greatly improves the efficiency of the system. Performances of the amplifier are very stable and consistent, regardless of the quality of the mains. This also grants a worldwide compatibility of the power supply - from 90V to 265V 50/60Hz - and limits power consumption.
Preset System
Preset SystemThe opportunity of modifying the character and equalization of a speaker is a very important prerogative in adapting a speaker to multiple functions. The introduction of the Preset System enables to choose directly from the box the most adeguate equalization for the desired use, optimizing performances without the need of external processors. The management of phase, limiter and x-over will be modified automatically depending on the chosen set-up, preserving the internal acoustic equipment.
RDNet
RDNetDigital net for bi-directional control of connected devices. The acronym RDNet originates from the development, on behalf of RCF and dBTechnologies, of a universal network which allows adjustments in real time and supervision of all the connected systems, using cables based on ethernet cat 5 wires. With the specific software and the interfaces control 2 and control 8, a complete command of the acoustic system will be possible allowing real time supervision on each electrical component of the various speakers. RDNet allows you to monitor levels, limiters, and temperatures, select system presets, configure setups off-line, Mute units, Group modules and assigning group EQ, delay and phase, test individual components, automatically address system components, tap into LAN and USB interfaces, extend the network via wireless LAN access points.
SMPS
SMPSAn SMPS is an electronic power supply that uses high-frequency switching and control circuits to convert electrical power efficiently. It transforms input voltage (AC or DC) to a regulated output voltage with minimal energy loss. Commonly used for its high efficiency, small size, and lightweight design.
Product code: 103010201
Caractéristiques techniques
Speaker Type
3-Way Active Line Array Module

Caractéristiques acoustiques
Frequency Response [-6dB]
66 - 18.000 Hz

Max SPL
One Unit: 132 dB

HF
2x1 "

Voice Coil HF
1.4 "

Directivity
100x15 ° Single unit

MF
1x 6.5 "

Voice Coil MF
2 "

LF
8 "

Voice Coil LF
2.5 "

Amplificateur
Amp Technology
Digipro® G2

Amp Class
Class D

HF Amp
175 W RMS

MF Amp
175 W RMS

LF Amp
350 W RMS

Cooling
Convection

Processeur
Controller
DSP 56 bit with double precision filters

AD/DA Converter
24 bit/96 kHz

System Presets
9, (8xHF and Low-mid correction)

Limiter
Dual Active Limiter

Multiband RMS, Peak, Thermal

Crossover Frequency MF-HF
1900 Hz

Slope MF-HF
24 dB/Octave

Crossover Frequency LF-MF
400 Hz

Slope LF-MF
24 dB/Octave

Input Section
Signal Input
1x XLR fem, Bal.

Signal Output
1x XLR male, Bal.

Network
RDnet remote control RJ45 connector IN/OUT

Power Socket
1x Powercon In

1x Powercon Out

Voltage Range
90 - 240 V

Mécanique
Housing
Polypropylen PP

Metal reinforced

Housing Design
Trapezoidal 15°

Rain Cover
Included

Rigging Points
Integrated rigging hardware

Width
580 mm (23.2 in)

Height
240 mm (9.6 in)

Depth
327 mm (13.08 in)

Weight
14,2 kg (31.3 lbs)

Notes: The data are not binding; dBTechnologies reserves the right to modify the data at any time and without previous notice.
Filename: Category: Filetype: Size: Language: Release:
DWG_DVA-T8 Drawing DWG 0,78 MB English 2015-06-01
Brochure_DVA-Series Catalogues PDF 2,56 MB English 2013-11-20
CE_DVA-T8 Certifications PDF 0,93 MB Italiano 2016-10-25
Datasheet_DVA-T8 Data Sheet PDF 1,53 MB English 2015-02-18
Manual_DVA-T8_Rev2.0 Manual PDF 10,77 MB English 2015-02-18
FW_DVA-T8_FIR_v1.2 Firmware ZIP 0,15 MB English 2025-05-12
FW_T8-NO-FIR_v2.0.1.dbu Firmware ZIP 0,14 MB English 2015-07-06
GLL_DVA-TSeries_v1.1.exe GLL ZIP 14,39 MB English 2022-09-09
DS 2

DS 2

Installation
DAC 15

DAC-15

Câbles
RJ45 RJ45 75

RJ45-RJ45-75

Câbles
DPC 15 section

DPC-15

Câbles
DCK 15 section

DCK-15

Câbles
DCK 45 section

DCK-45

Câbles
temp 0a510a0146eb4b80a346e8d7ba7290b8

Flight case

Transport
DT 6

Chariot

Transport
DF4

Flight case

Transport
DRK 20

DRK-20 - Fly Bar (système de suspension)

Installation
DRK 10

DRK-10 - Fly Bar (système de suspension)

Installation
DSA 4

DSA 4

Installation
Sales & Rental Network